Car DVR HT200A Full HD 1920*1080P 30FPS 4X digital zoom waterproof HDMI H.264 sport action camera

Car DVR HT200A Full HD 1920*1080P 30FPS 4X digital zoom waterproof HDMI H.264 sport action camera
  • 5.0Mega pixels COMS sensor
  • 120degree 5G All Glass Lens
  • 720p(1280*720)/30FPS.VGA(640*480)/60FPS
  • SD Card slot (Support Max.32GB SDHC)
  • Bulit-in microphone

The camera works well and takes great 1080P HD movies in the daytime but night performance is quite poor, not as good as some other less expensive cameras. The video is dark and everything looks brown and fuzzy at night so it's best to use this model just in the daytime. Also it's a sports cam not a car DVR. Although it can be used in a car it won't come on and start recording automatically. It also has a few other issues. Due to being waterproof there is a heavy rubber cover over the buttons that makes them hard to press. Also the mic, which is inside the case, doesn't pick up much sound unless the back cover is open but with it open you get a lot of rattling noise. The mounting hardware also has issues. The angle bracket and the suction cup mount connect with 4 small prongs but they have a bump on them that prevents sliding into the holes they are supposed to go into. I had to file them off a bit before they would go together. The suction cup is large and has a sticky surface that stays on when it's attached but the prong that the camera sits on is small and lets the camera vibrate and bounce around all the time. Also the knob that is turned to attach the suction cup has a big detent it drops into when it's turned all the way on but then it won't easily come undone to remove it. I purchased different mounting hardware on ebay to use instead of the supplied one, a different suction cup with a metal camera mount attached to it that doesn't vibrate. In addition the mounting plate on the bottom of the camera is attached with 8 small screws that go into little plastic pins and 3 of them are starting to break already so it will probably have to be glued on with epoxy eventually.

0 comments:

Post a Comment